Wired smart power system in KNX protocol
This is without a doubt the most common system in Israel and Europe. Has an Israeli and European standard mark and infinite flexibility by virtue of being an open system.
Preparations required for light bulbs, shutters, shades and special operations such as boilers, steam diffusers and towel warmers:
A 20 mm diameter direct wire to the electrical panel for any circuit, shutter or operation.
Separation must be done between dimmed lighting circuits and a standard on and off circuit.
A twisted circuit requires two pipes for the electrical board, the first for operating voltage and the second for command (low voltage).
Preparations required for an air conditioning and underfloor heating system:
The type of air conditioner and the desired mode of control over it, will determine the type of preparation required. It is recommended to link the air conditioning company to the operating smart electricity company.
Preparations required for smart detectors:
Direct pipe to the electrical panel or switch with a diameter of 20 mm. Sometimes a concrete box is also required depending on the type of detector and how it is implemented.
Preparations required for smart switch:
Direct pipe to the electrical panel with a diameter of 20 mm. Usually thread up to 10 switches together and run the last one to the board in a separate 20 mm pipe. A concrete box is required for the designated circuit breaker. In most cases, this is a 3-place gewiss box or a standard round box (also known as a 55 box).
There should be space left on the board for the smart electrical controllers.
VITREA wireless smart electricity system
The most common and reliable wireless system in Israel. The preparations rely on a standard “stupid” infrastructure, except for the zero tendon (the blue tendon), which must be added to each circuit breaker. The system uses 3 and 4 place gewiss boxes. Ignition planning should be planned in advance to avoid excess or lack of required sessions.
This system also has the ability to interface with air conditioning and underfloor heating systems, and similar to to KNX systems, the type of air conditioner and the desired mode of control over it will determine the type of preparation required. It is recommended to link between the air conditioning technician to company and the operating smart company for optimal results.
